OWNER’S INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MANUEL D’UTILISATION
ISTRUZIONI PER L’USO
MANUAL DE INSTRUÇÕES
GEBRAUCHSANWEISUNG
√¢∏°π∂™ Ã∂πƒπ™ª√À
àçëíêìäñàü èéãúáéÇÄíÖãü
FH052EAMT
FH070EAMT
System Air Conditioner (Cool and Heat)
Aire acondicionado sistemático (Refrigeración y Calefacción)
Climatiseur numérique multifonctionnel (Refroidissement et Chauffage)
Sistema Aria Condizionata (Raffreddamento e Riscaldamento)
Sistema Ar Condicionado (Refrigeração e Aquecimento)
Klimaanlage System (Kühlen und Wärmen)
™‡ÛÙËÌ· ∫ÏÈÌ·ÙÈÛÌÔ‡ (æ‡Í˘ Î·È £¤ÚÌ·ÓÛ˘)
ëËÒÚÂÏÌ˚È ÇÓÁ‰Û¯Ì˚È äÓ̉ˈËÓÌ (éı·ʉÂÌËÂ Ë Ó·Ó„Â‚)
E S F I P D G R DB98-15121A(1)
Contents
◆
PREPARING YOUR AIR CONDITIONER
◆◆◆Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
◆◆◆View of the Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
◆◆◆Wireless Remote Controller-Buttons and Display . . . . . . . . . . . 6
◆◆◆Wired Remote Controller-Buttons and Display . . . . . . . . . . . . . 7
◆◆◆Centralized Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
◆◆◆Function Controller . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
◆
◆
RECOMMENDATIONS FOR USE
◆◆◆Adjusting the Air Flow Direction . . . . . . . . . . . . . . . . . . . . . . . 10
◆◆◆Operating Recommendations . . . . . . . . . . . . . . . . . . . . . . . . . 11
◆◆◆Temperature and Humidity Ranges . . . . . . . . . . . . . . . . . . . . 12
◆◆◆Cleaning Your Air Conditioner . . . . . . . . . . . . . . . . . . . . . . . . 13
◆◆◆Solving Common Problems . . . . . . . . . . . . . . . . . . . . . . . . . . 14
TECHNICAL SPECIFICATIONS
E-3
View of the Unit
The figures are shown in this instruction may differ from yours depending on the model.
Indoor Unit
Air flow blade(up / down)
Air flow blade(right / left)
Air filter
Front grille
Remote control sensor
Defrosting indicator
Filter sign indicator
Fan indicator
Auto indicator
Timer indicator
Operation indicator
On / Off button
E-4
Outdoor Unit
Air outlet
Connection valve
If the heat exchanger in the outdoor unit gets dusty, cooling efficiency may fall.
So clean the heat exchanger with water when it becomes dirty. However, be careful when you
wash the surface of the heat exchanger because it is very sharp.
No t e
E-5
Wireless Remote Controller-Buttons and Display
The wireless remote controller is an optional accessory.
To use the wireless remote controller, refer to an appropriate manual.
Mode selection button
Operating mode
Temperature adjustment
buttons
Temperature setting
Filter Reset button
Fan speed
Fan speed adjustment
button
Air flow direction
Swing button
On Timer setting
On Timer button
Off Timer setting
Off Timer button
Battery discharge indicator
On/Off & Timer
Set/Cancel button
No t e
◆ After cleaning the air filter, press the filter reset button.
E-6
Wired Remote Controller-Buttons and Display
The wired remote controller is an optional accessory and it is installed on the wall.
To use the wired remote controller, refer to an appropriate manual.
Operating mode
Removing frost indicator
Centralized controller indicator
(In case of installing the Centralized controller)
Communication error indicator
Temperature setting
Fan speed
On Timer setting
Off Timer setting
Air flow direction
Test indicator
Filter Sign indicator
On/Off & Timer
Set/Cancel button
Temperature adjustment
buttons
On/Off indicator
On Timer button
Fan speed adjustment
button
Off Timer button
Swing button
Test button
Filter Reset button
Mode selection button
No t e
◆ Test button is for your installation specialist. You must NOT press it.
◆ After cleaning the air filter, press the filter reset button. Then the wired remote
controller will display the FILTER SIGN indicator when the time to clean the air filter;
refer to page 13.
E-7
Centralized Controller
The centralized controller is an optional accessory and it is installed on the wall.
To use the centralized controller, refer to an appropriate manual.
Front View
Operating lamp
All On button
All Off button
On/Off indicators
On/Off buttons
Index
No t e
◆ The operating lamp comes on even when only one air conditioner
connected to the centralized controller is operating.
Side View
Operating Mode Switch
COOL
AUTO
HEAT
No t e
◆ Choose the appropriate operating mode with the Operating Mode Switch
that enables the user to choose between the Cool/Auto/Heat mode.
E-8
Function Controller
The function controller is an additional controller which is used with the centralized controller.
To use the function controller, refer to an appropriate manual.
Operating mode
Removing frost indicator
Centralized controller indicator
Communication error indicator
Temperature setting
Room number display
Fan speed
Air flow direction
Test indicator
Filter Sign indicator
On/Off & Timer
Set/Cancel button
Temperature adjustment
buttons
On/Off indicator
Fan speed adjustment
button
Indoor unit selection button
Swing button
Test button
Filter Reset button
Mode selection button
No t e
◆
Test button is for your installation specialist. You must NOT press it.
◆ After cleaning the air filter, press the filter reset button. Then the wired remote controller
will display the FILTER SIGN indicator when the time to clean the air filter.
E-9
Adjusting the Air Flow Direction
There are two sets of inner air flow blades. Just as the outer air flow blade
can be adjusted vertically, the inner blades can be adjusted horizontally.
Adjust each set of inner blades to the required position, by pushing or
pulling them sideways.
E-10
Operating Recommendations
Here are a few recommendations that you should follow w hen operating
your air conditioner.
Topic
Recommendation
Heating
The heat pump function of the air conditioner absorbs heat
performances from outside air and brings it indoors. As the temperature of the
outside air drops, the heating performance of air conditioner will
decrease. If you find that the room is not warm enough, using
an additional heating appliance is recommended.
Frost
When outside temperature is low but humidity is high,
frost may form on the outdoor unit at HEAT mode.
If this happens:
◆◆The heating operation stops.
◆◆The defrost mode will be triggered automatically for about ten
minutes.
No intervention is required ; after about ten minutes, the air
conditioner operates again normally.
High indoor
and outdoor
If both indoor and outdoor temperatures are high and the air
conditioner is running at HEAT mode, the outdoor unit’s fan
temperatures and compressor may stop at times.
This is normal ; simply wait until the air conditioner switches
on again.
Power failure
If a power failure occurs while the air conditioner is operating,
the unit will be switched off. When the power returns, the air
conditioner starts up again automatically.
E-11
Temperature and Humidity Ranges
The follow ing table indicates the temperature and humidity ranges,
w ithin w hich the air conditioner can be used.
If the air conditioner is used at...
Then...
High temperature
The automatic protection feature may be
triggered and the air conditioner stopped.
Low temperature
A water leakage or some other
malfunction may happen if the heat
exchanger freezes.
High humidity levels
Water may condense on and drip from
the surface of the indoor unit if it is used
for a long periods.
Mode
Heating
Cooling
Drying
Outdoor Temperature
-5°C to 24°C approx.
-5°C to 43°C approx.
-5°C to 43°C approx.
Indoor Temperature
27°C or less
Indoor Humidity
-
21°C to 32°C approx.
21°C to 32°C approx.
80% or less
-
◆◆ If the heating operation is used at below -5°C (outdoor temperature)
then, it does not heat at its full capacity.
If the cooling operation is used at over 32°C (indoor temperature) then,
it does not cool at its full capacity.
E-12
Cleaning Your Air Conditioner
To get the best possible use out of your air conditioner, you m ust to
clean it to rem ove the dust that accum ulates on the air filters.
Before cleaning your air conditioner, ensure that you
have sw itched off the breaker used for the unit.
IMPORTANT
1
2
Open the front grille by pushing on both sides and center.
Pull the air filters in upward direction to remove them.
Remove all dust from the air filters by vacuum cleaner, brush or by
washing them with a detergent and warm water below 40°c.
After washing, allow them to dry thoroughly in an area protected from
sunlight.
3
4
Insert the air filters to the front grille.
Close the front grille by pushing both sides and center.
Not e
No t e
◆◆ If you have not used the air conditioner for a long period of time, set the fan
going for three or four hours to dry the inside of the air conditioner thoroughly.
◆◆ If you don't clean the air filter at least every two weeks, its performance may
be reduced and noise may increase.
◆◆ After cleaning the air conditioner, press the Filter Reset button.
Wired Remote Controller
Wireless Remote Controller
E-13
Solving Common Problems
Before contacting the after-sales service, perform the follow ing simple checks.
They may save your time and expense of an unnecessary call.
Problem
Explanation/Solution
The air conditioner does not ◆ Check that the breaker used for the air conditioner is switched on.
operate at all
Wired Remote Controller
The air conditioner does not
operate with the remote
controller
◆
is displayed on the wired remote controller. In this case,
turn the air conditioner off and contact your dealer.
Wired Remote Controller
When turning on/off the
air conditioner, it is not
◆ In case of using the wired remote controller for a group, the air
conditioners connected to the remote controller are turned on/off in
order. Thus, it takes some time(up to 32 seconds).
turned on/off immediately.
Wireless Remote Controller
The air conditioner does not ◆ Check that there are no obstacles between you and the remote
operate with the remote
controller
control sensor.
◆ Check the wireless remote controller batteries.
◆ Check that you are close enough to the remote control sensor.
(seven metres/yards or less).
Wireless Remote Controller
No beep is heard when you ◆ Check that you are pointing the remote controller at the remote
press
(ON/OFF) on the
control sensor on the indoor unit.
remote controller
◆ Replace the remote controller batteries if necessary.
◆ If there is a strong light around the air conditioner, a
three-wavelength light, a neon sign, etc., for example,
the air conditioner may not be operated with a remote controller.
If this happens, use the remote controller close by the remote
control sensor.
The air conditioner does
not cool or heat
◆ Check that the correct operating mode has been selected.
◆ The room temperature may be too low or too high.
◆ Dust may be blocking the air filter guard; refer to page 13
for cleaning instructions.
◆ Check that there is no obstacle in front of the outdoor unit.
When heating, the required ◆ Check that the required temperature has been set correctly.
room temperature is never
reached and the air
◆ Increase the fan speed.
conditioner frequently stops
E-14
Technical Specifications
Model
Power Supply
FH052EAMT
1Ø, 220-240V~, 50Hz
FH070EAMT
E-15
THIS AIR CONDITIONER IS MANUFACTURED BY:
ESTE AIRE ACONDICIONADO HA SIDO FABRICADO POR:
CE CLIMATISEUR EST FABRIQUE PAR:
QUESTO CONDIZIONATORE D’ARIA È PRODOTTO DA:
ESTE APARELHO DE AR CONDICIONADO É FABRICADO POR:
DIESE KLIMAANLAGE IST FABRIZIERT VON:
AYTH H ™Y™KEYH KATA™KEYA™THKE A¶O:
ùíéí äéçÑàñàéçÖê àáÉéíéÇãÖç îàêåéâ:
ELECTRONICS
Printed in Korea
|