Russell Hobbs Paint Sprayer X 10SW User Guide

January 2004  
X-10SW Hand-held Sprayer  
(Accessory To X-10 OC Chemical Delivery Systems)  
Operating and  
Maintenance Instructions  
 
Table of Contents  
Introduction  
1
2
2
3
3
4
4
4
Warnings  
Features  
Optional Accessories  
Operating Specifications  
Connection to X-10C Chemical Cylinder  
Pre-operational Use  
Operation of the X-10SW Hand-held Sprayer  
After Using or When Refilling the X-10SW  
with X-10C Chemical Cylinder Attached  
5
Limited Warranty  
Technical Support  
Replacement Parts  
8
8
9
 
 
Operating and Maintenance Instructions  
Introduction  
This manual will prepare site personnel to operate the X-10SW  
Handheld Sprayer. An orientation and training video can be used in  
conjunction with this manual. If you feel that additional instruction or  
procedures are necessary, please contact the factory regarding a training  
class.  
The X-10SW provides the ability to utilize the X-10C chemical cylinder  
with a handheld sprayer. The X-10SW sprayer has a pressure washer gun-  
grip handle with replaceable nozzle spray tip. The gun grip handle is  
furnished with a one-piece high pressure hose and fittings to match the  
X-10C chemical cylinder. High pressure swivel fittings allow easy wand  
movement and either right- or left-hand operation. All X-10C safety  
features are retained. There is only one releasable connector that attaches  
to the X-10C chemical cylinder. The X-10SW includes a safety chain to  
retain the high pressure hose should the connector become disconnected  
under pressure. The X-10C chemical cylinder can be conveniently carried  
in a washable backpack carrier. The X-10C is easily removed from the  
carrier for refilling.  
1
 
Operating and Maintenance Instructions  
Warnings  
The X-10SW Hand Held Sprayer must not be used by any officer  
until that officer has received training in X-10SW operation and  
the officer has also test fired the X-10SW.  
IMPORTANT - The X-10SW is a high pressure gas less-lethal  
weapon. Careful handling and proper training is required. The X-  
10SW high pressure hose contains Oleoresin Capsicum (pepper  
spray) under high pressure when the X-10C valve is opened. The  
pressure MUST BE RELEASED BEFORE the hose is discon-  
nected. When the X-10SW hose is disconnected from the X-10C  
chemical cylinder, be careful that no pepper spray chemical  
residue drips from the high pressure hose connector.  
Features  
Easy connection to your existing X-10C chemical cylinder  
Can be used with either 1-liter or 2-liter X-10C chemical  
cylinder  
Quick-disconnect high pressure swivel connectors  
Heavy-duty spray wand and hose assembly  
Pistol-grip handle with safety and interchangeable spray tips  
Choice of replaceable spray tips  
5-foot “soft-flex” high pressure hose and safety chain  
Washable backpack carrier with adjustable straps and carrying  
handle  
2
 
Operating and Maintenance Instructions  
Optional Accessories  
5-inch straight bore tip  
5-inch “Salinas” wide-angle spray tip  
Wide-angle fog tip  
26-inch flexible hose tip  
Operating Specifications  
Spray force:  
15 ft. lbs. at 3 feet, using straight bore nozzle  
Note: For ballistic test results, contact the  
factory.  
Recommended minimum shooting distance: 5 feet  
Do not shoot at head area within 8 feet for  
“Salinas” tip.  
Do not shoot at head area within 12 feet for  
straight bore tip.  
Average shots:  
1-liter chemical bottle – 21-1/4-second bursts  
2-liter chemical bottle – 47-1/4-second bursts  
Continuous spray: 1-liter chemical bottle – 5.6 seconds  
2-liter chemical bottle – 12.5 seconds  
Shooting distance: 32 feet – straight bore tip, 6-inch, level shooting  
43 feet – straight bore tip, 6 inch, +10-degree  
up shooting  
20 feet – “Salinas” wide-spray tip, 6-inch  
24 feet – 26-inch flexible hose with 4-inch  
straight bore tip  
Angle of spray:  
20 degrees – straight bore tip, 6-inch, level  
shooting  
50 degrees – “Salinas” wide-spray tip, 6-inch  
90 degrees – wide-angle fog tip  
3
 
Operating and Maintenance Instructions  
Connection to X-10C Chemical  
Cylinder  
Verify that the X-10C chemical cylinder valve is closed before  
attempting to attach the X-10SW hose. Carefully attach the X-  
10SW hose and verify that the connector is properly seated.  
Attach the X-10SW safety chain to the hole in the X-10C pres-  
sure gauge shroud. Verify that the safety on the spray wand pistol  
grip has been set before proceeding. DO NOT open the X-10C  
chemical cylinder valve until you are preparing to use the X-  
10SW sprayer. Pressurize the sprayer by carefully opening the X-  
10C chemical cylinder valve while observing the built-in pressure  
gauge. CAUTION: ALWAYS point the X-10SW/X-10C connec-  
tor away from you and in a safe direction before opening the X-  
10C valve. The X-10C at full pressure should be between 550 psi  
and 700 psi. An X-10C bottle used with the X-10SW handheld  
sprayer with 250 psi showing on the gauge can still have up to  
five remaining shots before refilling.  
Preoperational Use  
1. Try to talk inmate out of the cell.  
2. Evaluate the barricade and the attitude of the inmate.  
3. Decide the best location for probe insertion.  
4. Assemble officers who will operate X-10SW. Position each  
for best results depending on the amount of room available  
on the floor or tier.  
5. Inform inmate that you will be using the X-10SW and  
allow the inmate to come out voluntarily.  
4
 
Operating and Maintenance Instructions  
Operation of X-10SW Handheld  
Sprayer  
The X-10SW must be used in strict conformation with the  
Department Operational Procedures.  
1. Place the X-10C chemical cylinder in the fabric carrier.  
2. Fasten the Velcro flap and hose straps so the bottle  
cannot slip out of the fabric carrier.  
3. Place the carrier on your back in the same manner that  
you would any backpack.  
4. Fasten the chest strap and arrange the hose for either  
right-hand or left-hand operation as desired.  
5. Verify that the spray wand pistol grip safety lever is in the  
safe position before proceeding. Examine the spray wand  
tip to be sure that it is properly seated in the quick release  
connector. If not properly seated, the tip can be shot off  
the pistol grip with the first chemical shot.  
6. If you are using a “Salinas” or wide-angle fog tip, verify  
that the tip is properly oriented to provide the desired  
spray pattern.  
NOTE: The spray tips can rotate during repeated use or close  
contact, so check tip orientation before each use.  
After Using or When Refilling the X-  
10SW with X-10C chemical cylinder  
Attached  
After using the X-10SW, immediately close the X-10C chemical  
cylinder valve to stop further chemical flow to the wand. After  
closing the X-10C valve, the handheld wand must be sprayed in a  
5
 
Operating and Maintenance Instructions  
safe direction to release the remaining hose pressure. The pepper  
spray residue in the hose may drip if not contained.  
Whenever refilling the X-10C chemical cylinder, be sure to  
follow the procedures contained in the X-10OC Extension  
Device, Operating and Filling Instructions.  
IMPORTANT - The X-10SW is a high pressure gas less-lethal  
weapon. Careful handling and proper training is required. The X-  
10SW high pressure hose contains Oleoresin Capsicum (pepper  
spray) under high pressure when the X-10C valve is opened. The  
pressure MUST BE RELEASED BEFORE the hose is discon-  
nected. When the X-10SW hose is disconnected from the X-10C  
Chemical Cylinder, be careful that no pepper spray chemical  
residue drips from the high pressure hose connector.  
6
 
Operating and Maintenance Instructions  
7
 
Operating and Maintenance Instructions  
LimitedWarranty  
Priax Corporation makes no warranty, expressly or by implication,  
except as set forth below.  
Priax Corporation warrants that the products delivered hereunder  
will be in substantial conformity with applicable specifications  
and will be free from defects in material and workmanship. Priax  
Corporation’s obligation under this warranty shall be limited to  
(at its option) repairing, replacing, or granting a credit at the  
prices invoiced at the time of shipment for any of said products  
which shall, within 90 days after shipment, be returned to the  
factory of origin, transportation charges prepaid, and which are,  
after examination, disclosed to Priax Corporation’s satisfaction to  
be thus defective. This warranty shall not apply to any of such  
products which shall have been repaired or altered, except by  
Priax Corporation, or which shall have been subjected to physical  
or electrical abuse or misuse.  
THE WARRANTIES STATED HEREIN ARE IN LIEU OF  
ALL OTHER WARRANTIES EXPRESSED OR IMPLIED,  
AND PRIAX CORPORATION NEITHER ASSUMES NOR  
AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT  
ANY OTHER LIABILITY. PRIAX CORPORATION SHALL  
NOT BE LIABLE FOR SPECIAL OR CONSEQUENTIAL  
DAMAGES OF ANY NATURE WITH RESPECT TO ANY  
PRODUCTS OR SERVICES RENDERED HEREUNDER.  
NO PRODUCT IS WARRANTED TO BE FIT FOR ANY  
PARTICULAR USE OR APPLICATION.  
Technical Support  
Technical support is provided by Priax Corporation at no charge  
starting from the date of purchase. Priax Corporation will re-  
spond to all service calls made during the normal work week  
within a 24-hour period during normal business hours of 8:00  
AM to 5:00 PM (Pacific Standard Time).  
8
 
Operating and Maintenance Instructions  
Replacement Parts  
Replacement Components  
Part No.  
Description  
Pistol-grip handle assembly  
Quick-release connector, female for Tip, 1/4  
inch  
X-10SW-210  
X-10SW-211  
X-10SW-212  
X-10SW-213  
X-10SW-214  
X-10SW-215  
X-10SW-216  
Straight swivel  
Hose, 5-foot with male fittings  
Rotary joint, 90-degree swivel  
90-degree street ell, 3/8”  
Connector, male, mate to bottle, 3/8”  
Replacement Tips  
Part No.  
Description  
X-10SW-250  
X-10SW-255  
Nozzle tip, straight bore, 6-inch, stainless steel  
Nozzle tip, “Salinas” wide-spray, 6-inch,  
stainless steel  
X-10SW-256  
X-10SW-257  
Nozzle tip, wide-angle fog, stubby brass  
Nozzle tip, 26-inch flexible hose, 4-inch  
straight bore tip, stainless steel  
9
 

Pyramid Car Audio Power Supply PSV 300 User Guide
Radio Shack Calculator EC 293 User Guide
Radio Shack Conference Phone 43 3911 User Guide
Radio Shack Scanner PRO 2053 User Guide
Raymarine Microphone 86075 2 User Guide
RCA Universal Remote RCR4258N User Guide
Remington Blower RM193B User Guide
Ruby Tech Switch GS 1108C User Guide
Samsung Cooktop C21RJAN User Guide
Schumacher Battery Charger SE 2151MA User Guide