RocketFish Home Theater System 09 0474 User Guide

RF-RBKIT Wireless HD Audio Starter Kit  
Package contents:  
TM  
Wireless sender  
TM  
3.5 mm female-to-RCA  
stereo cable,  
Cable spool  
(for receiver)  
DC adapter AC power cable  
User Guide  
3.5 mm male-to-male  
stereo cable, 3ft (x2)  
IR remote  
Speaker cable,  
3 ft (x4)  
Quick Setup Guide  
6 in. (x2)  
(for sender)  
(for receiver)  
Wireless receiver  
Step 1 Preparing the remote control  
Toactivatethebattery: Removethetabfromthebottomofthe  
remotecontroltoenablethebattery.  
Please Read First  
Every Rocketboost network must contain at least one hub device, which directs network data traꢁc  
and helps devices join the network. The network can have only one hub, which can be enabled by  
using the hub switch on the back of all Rocketboost transmitters. The sender in this kit is set at the  
factory for hub mode and the receiver has been pre-joined to this sender at the factory for easy  
setup. If you have an existing Rocketboost network, the sender's hub mode switch should  
be set to Disable. The sender and receiver also need to be joined to your existing hub device  
(the one with the green power LED).  
Step 2 Connecting the sender  
Connecting to an ampliꢀer  
(surround mode is described below, as an example)  
Connect the right surround speaker terminals of your ampliꢀer  
to the right speaker terminals of the sender by connecting the  
red speaker wire to the red (+) terminals, and the black  
speaker wire to the black (-) terminals. Repeat to connect the  
left surround speaker terminals.  
See your User Guide for instructions on joining devices to the network.  
Sender  
Connecting to an external audio source  
(such as an MP3 player)  
TM  
TM  
Connect external audio source(s) to the Pre-in A and/or B jacks  
on the rear of sender using the 3.5 mm male-to-male stereo  
cable and the 3.5 mm female-to -RCA stereo cable.  
Note: The Input A/Input B buttons on the remote control allow  
you to select between the Speaker in or Pre in (line level). Each  
press of the button will toggle to the other source. The unit  
must be powered up for these buttons to operate and the  
state when powered down will be remembered.  
12  
13  
14  
15  
11  
16  
1
2
3
4
5
6
7
8
Standby LED  
9
HD B button  
Power/Join button  
Power/Join indicator  
HD A indicator  
10 HD B indicator  
11 DC IN jack  
12 SPEAKER IN A jacks  
13 Pre-in A/B jack  
HD A button  
Step 3 Connecting the receiver  
Source A button  
Source A/B LED indicator  
Source B button  
14 SPEAKER IN B jacks  
15 Hub Enable switch  
Connect the right surround speaker  
to the right speaker terminals on the  
receiver. Use a red speaker wire to  
connect the red (+) terminals and a  
black speaker wire to connect the  
black (-) terminals.  
SPEAKER-OUT (4-8 Ohm)  
16 4 -Channel Lock switch  
2
3
1
4
5
6
8
9
7
10  
AC IN  
120V~,60Hz  
Receiver  
R
L
SPEAKER-OUT (4-8 Ohm)  
9
10  
Repeat this step to connect the left  
surround speaker.  
AC IN  
120V~,60Hz  
TM  
TM  
R
L
Step 4 Establishing communication  
11  
12  
13  
14  
The sender and receiver packaged together were pre-joined at the factory, so if you are only using one  
sender and receiver set, no further conꢀguration is needed. If an active link is established between them,  
the Power/Join indicators on both units will light steadily (no blink). If your sender and receiver are  
not correctly linked (the power LEDs will ꢀash slowly) or you need to add additional Rocketboost products, see  
your User Guide for more information. Make sure the Source A or B LED is illuminated on the sender for the  
channel that you have connected to your network for the audio transmission to be active.  
Press the SOURCE button on the receiver until the audio channel you desire is playing.  
Adjust the volume as desired.  
1
2
3
4
5
6
7
8
Standby LED  
9
IR sensor  
10 VOLUME knob  
Power/Join button  
Power/Join indicator  
BASS button  
11 Removable cable spool slot  
12 AC IN jack  
13 Removable cable spool slot (line level)  
14 SPEAKER OUT jacks  
Bass indicator  
SOURCE indicator  
SOURCE button  
HD indicator  
2
3
1
4
5
6
8
7
09-0474  
QUICK SETUP GUIDE  
 

Q See Digital Camera QD113P User Guide
Radio Shack Cordless Telephone ET 1110 User Guide
Rangemaster Refrigerator U109200 03 User Guide
Raritan Engineering Indoor Furnishings SeaEra Toilets User Guide
Reebok Fitness Treadmill RBTL69920 User Guide
Roberts Radio Portable Radio R761 User Guide
Saitek Video Game Controller Cyborg 3D User Guide
Samsung DVD VCR Combo SV DVD3E User Guide
Samsung Flat Panel Television LA52A610A3R User Guide
Samsung Printer ML 2510 User Guide