Roberts Radio Clock Radio CR9952 User Guide

CR9952  
Alarm Clock Radio  
Please read this manual before use  
 
Controls  
Front  
Back  
5
6
7
4
3
2
1
8
1. Clock Display  
2. Minute hand  
3. Hour hand  
6. Battery Cover  
7. Light Mode button  
8. Mains Supply Socket  
4. Alarm hand  
5. Second hand  
 
2
Controls  
Top  
13  
12  
11  
14  
15  
10  
9
9. Tuning scale  
13. Speaker  
10. Radio On/Off button  
11. Sleep button  
14. Alarm/Off button  
15. Light/Off button  
12. Snooze button  
 
3
Controls  
Left hand side  
Right hand side  
16  
18  
19  
17  
20  
16. Time Set control  
17. Alarm Set control  
18. Tuning control  
19. FM/MW switch  
20. Volume control  
If you need any further advice, please call our Technical Helpline on :-  
 
4
02087580338(Mon-Fri)  
Batteries  
1. Press the On/Off button to switch the radio off before replacing  
batteries.  
1
2. Open the battery cover located on the rear of your clock radio by  
pressing the catch down and pulling the battery cover towards you.  
3. Insert 4 x AA batteries into the compartment. Make sure the (+) and  
(-) ends of the batteries are positioned as shown inside the  
compartment.  
4. Close the battery cover.  
2
5. Press the On/Off button to switch the radio on after batteries have  
been replaced.  
6. If the radio is not to be used for an extended period of time it is  
recommended that the batteries are removed from the radio.  
5
3
 
5
Switching on and setting the time  
Before using your alarm clock radio you must first set the correct time.  
1. Check that the batteries have been installed correctly.  
2. Place the unit on a flat surface.  
3. Press in and turn the Time Set control.Rotating the control will  
move the clock hands, continue until the correct time is reached.  
3
If you need any further advice, please call our Technical Helpline on :-  
 
6
02087580338(Mon-Fri)  
Listening to the Radio  
1. Switch on the clock radio by pressing the On/Off button  
1
2. Slide the FM/MW switch to the required waveband.  
2
3. Tune in to the desired station by rotating the Tuning control.  
The station frequency is indicated in the Tuning scale.  
The Wire aerial located on the rear of your clock radio is for FM  
reception. The wire should be fully extended and positioned for  
optimum reception.  
3
For MW reception there is a built in ferrite aerial. Rotate your clock  
radio to the position giving the best reception.  
4. Adjust the volume by rotating the Volume control.  
5. To illuminate the clock face whilst listening to the radio, press the  
Light/Off button: this will give a Green backlight.  
4
6. To change the static Green backlight to a cycling Green/Blue/  
Red backlight, depress the Light Mode button and release.  
The cycle interval is approximately 15 seconds.  
6
7
7. To return to a static Green backlight, depress the Light Mode  
5
button once more.  
8. To turn off the Backlight at any time press the Light/Off button.  
9. The radio can be switched off by pressing the On/Off button.  
8
9
 
7
Setting the alarm time  
The alarm can be set to wake you by a buzzer.  
1. Press the Alarm/Off button.  
1
2. Press in and turn the Alarm Set dial. Rotating the dial will move the  
alarm hand, continue until the correct time is reached.  
The buzzer will sound at the preset time. After a few seconds the  
buzzer will sound more urgently and a few seconds later will change  
its tone again.  
2
3. The clock display will turn to a Red backlight whilst the alarm  
sounds.  
4. To turn off the alarm and the Red backlight, press the Alarm/Off  
button.  
4
If you need any further advice, please call our Technical Helpline on :-  
 
8
02087580338(Mon-Fri)  
Snooze control  
1. The buzzer alarm can be silenced for 5 minutes by pressing the  
Snooze button. This sequence can be repeated during the 90 minute  
alarm period.  
1
Sleep function  
1. The radio can be set to switch off automatically after a preset time  
has elapsed.  
2
4
2. Press the Sleep/Off button. The radio will stay on for 59 minutes,  
then turn off automatically.  
3. If the Backlight is illuminated at the time of pressing the Sleep/Off  
button, the Backlight will change from green to blue. On completion  
of the sleep elapsed time, the radio and Backlight will turn off.  
4. To cancel the sleep function before the preset time has expired,  
press the On/Off button.  
 
9
Backlight  
The Backlight illuminates the clock display, making it easy to view in  
a dark environment.  
1
1. Press and hold the Light/Off button on the top of the clock to turn  
on the Green backlight. The light will go off once the button is  
released.  
If you need any further advice, please call our Technical Helpline on :-  
 
02087580338(Mon-Fri)  
10  
Using the AC adaptor  
Your clock radio is supplied with a Mains Adaptor.  
1. Place your clock radio on a flat surface.  
2. Insert the adaptor plug into the DC socket located on the rear of your  
clock radio.  
3. Plug the adaptor into a standard 13 amp mains socket outlet.  
Whenever the adaptor is used, the batteries are automatically  
disconnected.  
The AC adaptor should be disconnected from the mains supply and  
the radio when not in use. The AC adaptor for use with the CR9952  
should provide 4.5 volts DC output at 300mA, centre pin negative.  
We would recommend for economy that your radio is used via the  
AC adaptor whenever possible with battery operation for occasional  
or stand-by use only.  
 
11  
Notes  
If you need any further advice, please call our Technical Helpline on :-  
 
12  
02087580338(Mon-Fri)  
Specifications  
Power Requirements  
Mains  
Circuit Features  
Loudspeaker  
8 ohms  
AC230 volts, 50Hz~ only  
DC4.5 volts, 300mA  
Adaptor Output  
Battery  
Output power 0.8 Watts  
4 x LR6 (AA Size) alkaline  
Aerial System  
FM  
Wire Aerial  
Frequency Coverage  
FM  
87.5 - 108MHz  
525 - 1605kHz  
MW  
Built-in Ferrite Aerial  
MW  
The Company reserves the right to amend the specification without notice.  
General  
Do not allow this unit to be exposed to moisture (e.g. dripping or splashing) or to temperatures exceeding 70 degrees centigrade. It is recommended  
that the FM band be used wherever possible as better results in terms of quality and freedom from interference will usually be obtained than on  
the MW band.  
 
13  
Guarantee  
This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component  
breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced  
free of charge.  
The guarantee does not cover:  
1. Damage resulting from incorrect use.  
2. Consequential damage.  
3. Receivers with removed or defaced serial numbers.  
Procedure:  
Any claim under this guarantee should be made through the dealer from whom the instrument was purchased. It is likely that your Roberts' dealer  
will be able to attend to any defect quickly and efficiently, but should it be necessary the dealer will return the instrument to the company’s service  
department for attention. In the event that it is not possible to return the instrument to the Roberts' dealer from whom it was purchased, please  
contact Roberts Radio Technical Services department at the address shown on the rear of this manual before taking further action.  
These statements do not affect the statutory rights of a consumer.  
If you need any further advice, please call our Technical Helpline on :-  
 
14  
02087580338(Mon-Fri)  
ROBERTS RADIO TECHNICAL SERVICES  
97-99WortonRoad  
IsleworthMiddlesex  
TW76EG  
Technical Helpline:- 020 8758 0338 (Mon-Fri)  
Issue 1  
 

Radio Shack Cell Phone ET 531 User Guide
Radio Shack Network Router 25 3187 User Guide
RCA Flat Panel Television 46LB330B5 User Guide
Renesas Network Card PCA7447FP User Guide
Russell Hobbs Iron SW U WC202P User Guide
Russound Stereo Amplifier CA Series User Guide
Samsung Cell Phone 4g User Guide
Samsung Refrigerator SRS536NP User Guide
Sanyo Battery Charger HR 4U User Guide
Schumacher Battery Charger 9275A PE User Guide