Radio Shack Switch 61 3005 User Guide

setting up your wall switch  
installing your wall switch  
Set the House Code  
dial to the same letter  
that you set on your  
Controller.  
Turn the power off at the circuit breaker  
61-3005  
panel.  
home automation  
wall switch  
Remove your wall plate and unscrew  
the existing switch from its box.  
Set the Unit Code  
Disconnect the wiring from your  
existing switch, and connect the two  
wires on your new switch using the  
wire nuts provided.  
dial to an unused code.  
Turn the ON/OFF  
switch beneath the  
push button to ON  
(center position).  
Wall Switch  
Wire nuts  
Replace the wall plate  
on your wall box.  
Push  
button  
ON/OFF  
Wires  
operating your wall switch  
Turn the power back on at the circuit  
breaker panel.  
Screws  
Push the button to turn your wall switch  
on or off.  
Be sure no loose wires are protruding;  
use insulating tape (not provided) to  
cover the wire nuts, if necessary.  
Thank you for purchasing the RadioShack Home  
Automation Wall Switch. Your Wall Switch is  
designed to control incandescent lights only,  
with rating between 40W and 500W. It replaces  
your existing switch, and controls both indoor  
and outdoor ceiling lights. A push button is  
provided for local on/off control.  
Note  
When replacing a light bulb, turn  
your wall switch to OFF  
(left position).  
Note  
Screw the switch into its wall box.  
Wall switches must not be used to  
control appliances, low voltage lamps  
Warning  
WARNING: To reduce the risk of fire or shock hazard, do not expose this  
product to rain or moisture.  
or fluorescent lamps!  
what’s included  
RISK OF ELECTRIC SHOCK.  
DO NOT OPEN.  
2 screws  
2 wire nuts  
user’s guide  
Please read this User’s Guide before  
installing, setting up, and using your new product.  
wall switch  
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE  
COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING  
TO QUALIFIED PERSONNEL.  
This symbol is intended to alert you to the presence of  
uninsulated dangerous voltage within the product’s enclosure  
that might be of sufficient magnitude to constitute a risk of  
electric shock. Do not open the product’s case.  
This symbol is intended to inform you that important  
operating and maintenance instructions are included in the  
literature accompanying this product.  
©2004. RadioShack Corporation.  
All rights reserved. RadioShack and RadioShack.com are  
trademarks used by RadioShack Corporation.  
61-3005  
06A04  
Printed in China  
 

Razor Mobility Scooter 13114501 User Guide
RocketFish Camcorder Accessories RF TRP47C User Guide
Roland Car Amplifier SA 1000 User Guide
Rose electronic Switch MAN VR2 User Guide
Samsung DVD Player DVD HR725 User Guide
Samsung Flat Panel Television HP R4262 User Guide
Samsung Home Theater System RTS E10 User Guide
Samsung Printer ML 2510 User Guide
Samsung Telephone SPH M560 User Guide
Sanyo CRT Television DS27930, DS32424 User Guide