Radio Shack Blood Pressure Monitor 63 1514 User Guide

Step Three  
Arm Cuff Blood  
Pressure Monitor  
63-1514  
5. Fasten the cuff snugly, leaving at least a  
finger’s room in between the cuff and your  
arm.  
Attaching the Arm Cuff  
1. Roll up your sleeve to prevent constricting  
circulation to your arm.  
2. Insert the plug  
at the end of  
the tube into  
the jack on the  
left side of the  
monitor.  
Step One  
Installing Batteries  
1. Press the tab to lift up the battery compartment cover.  
3. Sit upright on  
6. Place your arm on the table so the cuff is at  
the same height as your heart. Be sure the  
inflation tube lines up with your arm  
2. Insert four AA batteries (not supplied) into the compartment as  
indicated by the polarity symbols (+ and –) marked inside.  
the chair, and  
with your palm  
face up, thread  
the cuff through your arm until it reaches  
your biceps, just above your elbow.  
Step Two  
Setting the Date and Time  
1. Press MODE. The month digit flashes.  
4. Adjust the cuff so the inflation tube is on the  
top of your arm as shown. Leave the cuff’s  
bottom edge about 0.8 to 1.2 inches (2 – 3  
cm) above the crease of your elbow.  
2. Repeatedly press (or hold down) SET to set  
the correct month.  
3. Repeat Steps 1 and 2 to set the date, hour,  
and minute.  
4. Press MODE to complete setting.  
3. Pull down the cover then press the cover down to snap it in  
place.  
What’s Included  
Auto Inflatable Arm Cuff  
When the display dims or the batteries weaken,  
display. Replace the batteries.  
appears on the  
!
Or  
Monitor  
Step Four  
Measuring Blood Pressure  
Using an AC Adapter  
Carry Pouch  
You can also power the blood pressure monitor using a 6V DC, 1A  
AC adapter. To connect an AC adapter to the blood pressure moni-  
tor, attach a size M Adaptaplug to the adapter with its tip set to  
positive. Insert the adapter’s barrel plug into the monitor’s DC 6V  
jack. Then plug the adapter into a standard AC outlet.  
1. PressSTART/STOP. All display segments appear briefly and the monitor automatically inflates to  
160 mmHg, or the necessary inflation level. The systolic rate decreases gradually, appears,  
G
TM  
Optional Accessories  
Body Fat Analyzer  
and flashes at the same rate as your heartbeat.  
2. Once your blood pressure is detected, the monitor deflates slowly. The blood pressure reading  
and pulse rate appear. The air pressure in the arm cuff releases.  
Environizer  
3. To stop the measurement at any time, press START/STOP.  
Rechargeable Batteries  
Battery Charger  
appears briefly when:  
#
You do not wrap or position the cuff around your arm correctly.  
You talk or move the body during measurement.  
You have incorrect posture.  
The batteries become weak and  
flashes.  
!
 

Pyramid Technologies CD Player CDR22P User Guide
QSC Audio Speaker System WideLine Array User Guide
Quick Eagle Networks Network Card 4262 User Guide
Raymarine Marine Instruments 150 400 User Guide
Roberts Radio Radio RD 27 User Guide
Samson Stereo Amplifier Acoustic User Guide
Samsung Clothes Dryer DV520 User Guide
Sanitaire Vacuum Cleaner SC3680 Series User Guide
Sanyo Cordless Telephone LC 2430 User Guide
Seiko Printer FB 390 User Guide