RCA Cassette Player 3 5362 User Guide

3-5362  
PLAYBACK  
To listen to a prerecorded cassette:  
SERVICE  
This product should be serviced only by those specially trained  
in appropriate servicing techniques. For instructions on how to  
obtain service, refer to the warranty included in this Guide.  
Attach your sales receipt to the booklet for future reference, or  
jot down the date this product was purchased or received as a  
gift. This information will be valuable if service should be  
required during the warranty period.  
1. Insert a cassette as explained above.  
2. Press the REW button to rewind the tape to its starting point  
if necessary.  
3. Press the PLAY button.  
4. Adjust VOLUME to desired level.  
Mini Cassette Recorder/Player  
with Variable Speed Playback  
User’s Guide  
VARIABLE SPEED PLAYBACK  
Purchase Date ______________________  
Name of Store ______________________  
During the Play mode, you can adjust the speed of prerecorded  
tapes by rotating the Variable Speed Playback knob towards the  
MAX (maximum) position. Tape playback will be approximately  
30-50 percent faster than normal at the full MAX position.  
FCC INFORMATION  
LIMITED WARRANTY  
What your warranty covers:  
This device complies with Part 15 of the FCC Rules. Operation  
is subject to the following two conditions: (1) This device may  
not cause harmful interference, and (2) This device must  
accept any interference received, including interference that  
may cause undesired operation.  
In accordance with FCC requirements, changes or modifica-  
tions not expressly approved by Thomson Consumer Electron-  
ics could void the user’s authority to operate this product.  
F.FWD AND REW  
When not in the Play mode, you can use these buttons to  
adjust the tape position. Press F.FWD to move the quickly  
forward. Press REW to move the tape quickly backward.  
Any defect in material or workmanship.  
For how long after the original purchase:  
One year.  
(The warranty period for rental units begins with the first  
rental or 45 days from date of shipment to the rental firm,  
whichever comes first.)  
CUE/REVIEW  
This feature is helpful in finding the beginning or the end of  
the recorded segment on the tape.  
When in the Play mode, press and hold the F.FWD or REW  
button and listen for a change from noise to silence (signaling  
the end of the recording) or from silence to noise (beginning of  
recording).  
When you reach the portion of tape you want to hear, release  
the F.FWD or REW button. Use the same procedure if you want  
to skip a prerecorded portion or if you want to hear the same  
portion again.  
What we will do:  
HEADPHONES USE  
When you attach headphones (not included), the speaker is  
automatically silenced for private listening.  
Make sure you turn down the volume on the unit before you  
put on headphones. Increase the volume to the desired level  
only after headphones are in place.  
Provide you with a new or, at our option, a refurbished unit.  
The exchange unit is warranted for the remainder of your  
product’s original warranty period.  
How to make a warranty claim:  
Properly pack your unit. Include any cables, etc., which were  
originally provided with the product. We recommend using  
the original carton and packaging materials.  
Remove cassette tapes or CDs from unit before shipping as  
these will not be returned.  
Include in the package evidence of purchase date, such as  
the bill of sale. Also print your name and address and a  
description of the defect. Send standard UPS or its equiva-  
lent to:  
TO INSERT OR REMOVE A CASSETTE  
Make sure all buttons are in their "off" (up) position before  
attempting to open the cassette compartment door.  
POWER  
AUTOMATIC STOP  
When the unit is operating in the Play or Record mode and the  
tape reaches its end, the unit will automatically shut itself off  
and return all buttons to their off position.  
There are two ways to supply power to your recorder:  
1. Grasp both sides of the cassette compartment door and lift up.  
2. Gently slide in a cassette with the exposed tape facing out  
and the side you want to hear/record on showing through  
the cassette door window.  
BATTERY INSTALLATION  
1. Press down on the battery door and slide in the direction of  
the arrow.  
2. Insert two "AA" batteries - not included- as shown in the  
diagram on the back of the unit.  
3. Replace the battery door.  
Thomson Consumer Electronics, Inc.  
Product Exchange Center  
32 Spur Drive  
3. Close cassette compartment door.  
ERASING CASSETTES  
To erase a tape or a portion of a tape, simply rewind and  
record over the unwanted material.  
MIC SENSITIVITY SWITCH  
Select HI sensitivity for recording at conferences or for general use.  
Select LO sensitivity for close dictation.  
El Paso, Texas 79906  
Pay any charges billed to you by the Exchange Center for  
service not covered by the warranty.  
Insure your shipment in case of loss or damage. Thomson  
accepts no liability in case of damage or loss.  
A new or refurbished unit will be shipped to you prepaid  
freight.  
IMPORTANT BATTERY INFORMATION  
PREVENTING ACCIDENTAL ERASURE  
Whenever you make a recording, any previous material on the  
tape is automatically erased.  
When you have a recording you want to keep permanently, break  
out the rear left tab of the side you want to save (as shown in the  
diagram).  
When a cassette with the tab broken out is inserted in the  
cassette compartment, accidental erasure is prevented by a lever  
in the mechanism that keeps the RECORD button from depressing.  
Alkaline batteries are recommended for best results. Using  
nickel-cadmium rechargeable batteries may result in shorter  
playing time.  
If you do not intend to use the unit for a month or more,  
remove the batteries to avoid leakage or subsequent  
damage.  
Dispose of batteries in the proper manner, according to  
federal, state and local regulations.  
Any battery may leak electrolyte if mixed with a different  
battery type; if inserted incorrectly; if all batteries are not  
replaced at the same time; if disposed of in fire; or if an  
attempt is made to charge a battery not intended to be  
recharged.  
RECORDING  
1. Insert a blank cassette.  
2. Select MIC sensitivity (HIGH or LOW).  
3. Press the RECORD button. (The PLAY button will automati-  
cally depress at the same time).  
What your warranty does not cover:  
Customer instruction. Your owner's manual provides  
information regarding the operating instructions and user  
controls. For additional information, ask your dealer.  
Installation and setup service adjustments  
Batteries  
Damage from misuse or neglect  
Products that have been modified or incorporated into other  
products.  
NOTE: If the RECORD button does not depress, see "Preventing  
Accidental Erasure."  
Cellophane tape can be placed over the broken tab if you decide  
later that you want to record over the material on that side.  
4. Speak normally into the microphone. To obtain optimum  
recording quality, place the recorder with the microphone  
freely exposed to sound source and as close as conveniently  
possible.  
NOTE: This unit is equipped with a cassette sensing mechanism. This  
mechanism prevents the RECORD button from being depressed when a  
cassette is not present.  
Discard leaky batteries immediately to avoid possible skin  
burns or other personal injury.  
Product purchased or serviced outside the USA  
Acts of God, such as but not limited to lightning damage.  
5. When you finish recording, press the STOP button.  
NOTES: The ALC (Automatic Level Control) will set the record level for  
optimum recordings, regardless of volume setting.  
Avoid recording near unwanted noise sources, such as air conditioners, fans, etc.  
CAUTION/CARE  
Do not expose the unit to extreme temperatures, such as those  
caused by a hot stove or the inside of a car parked in the  
summer sun. Such conditions can damage the unit. Always  
clean with a soft cloth, dampened with water only.  
Cleaning the Heads: Iron oxide particles eventually build up  
on parts that touch the tape. This can cause a muffled sound.  
Use liquid head cleaner or a head cleaning tape to clean the  
heads.  
Product Registration:  
AC/DC POWER CONVERTER (NOT INCLUDED)  
Please complete and mail the Product registration Card  
packed with your unit. It will make it easier to contact you  
should it ever be necessary. The return of the card is not  
required for warranty coverage.  
You can use an AC/DC power converter to operate your  
recorder. Plug the barrel end of the converter into the  
recorder's 3V DC jack - automatically disconnecting the  
batteries - and then plug into an AC household outlet.  
PAUSE  
The PAUSE feature allows you to momentarily stop tape  
activity in any mode without resetting the control buttons.  
To use, simply slide the PAUSE switch to the ON position to  
stop activity. Slide the switch back to the OFF position to  
resume activity.  
How state law relates to this warranty:  
This warranty gives you specific legal rights, and you may  
also have other rights which vary from state to state.  
If you purchased your product outside of the U.S.A.:  
This warranty does not apply. Contact your dealer for  
warranty information.  
©1997 Thomson Consumer Electronics, Inc.  
Trademark(s) ® Registered  
Marca(s) ® Registradas  
Model 3-5362  
20800020 (Rev. 0, E/S)  
97-08  
Printed in China  
 

RCA Clock Radio RC150I User Guide
RCA CRT Television 20F542T User Guide
Rosewill Corded Headset RHTS 8206 User Guide
Rosewill Network Card RNX N300 User Guide
Samsung Projection Television SP43Q5HL User Guide
Samsung Washer B1045A User Guide
SANRAD Switch I311205 User Guide
Sanus Systems Indoor Furnishings TVLCD User Guide
Sanyo Air Conditioner 12XS71 User Guide
Sanyo Battery Charger NC MQN04B User Guide